Makita BTD044 Mode D'emploi page 6

In this situation, release the switch trigger on
the tool and stop the application that caused
the tool to become overloaded. Then pull the
switch trigger again to restart.
If the tool does not start, the battery is
overheated. In this situation, let the battery
cool before pulling the switch trigger again.
NOTE:
The overheat protection works only with BL1415NA.
Switch action
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
1
013582
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
Reversing switch action
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
•
reversing switch lever to the neutral position.
A
1
013584
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for
counterclockwise rotation.
1. Switch trigger
1. Reversing
switch lever
B
When the reversing switch lever is in the neutral
position, the switch trigger cannot be pulled.
Turning on the lamp
CAUTION:
Do not look in the light or see the source of light
•
directly.
1
013583
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The light automatically goes out approximately 10
seconds after the switch trigger is released.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
Auto-Stop setting for number of impacts
This tool has a convenient auto-stop mechanism that
allows you to preset the desired number of impacts in
terms of the application. The tool then stops automatically
after reaching the preset number of impacts.
Setting for number of impacts
1
013664
1. Pull the switch trigger, and then release it.
2. Pull the switch trigger approximately 3 seconds
while pressing the indication button, and then
release the switch trigger and the indication
button.
3. The lamp on the left side of the display blinks so
that the number of first digit can be changed by
pressing the button.
4. Press the button and choose the desired number.
The displayed number changes fast by keeping
pressing the button. To set the first digit, pull the
switch trigger and then release it.
6
1. Lamp
1. Display
2
2. Indication button