Makita BTD044 Mode D'emploi page 10

013585
Use a screwdriver to remove two screws then remove
the rear cover.
1
013586
Raise the arm part of the spring and then place it in the
recessed part of the housing with a slotted bit
screwdriver of slender shaft or the like.
013587
Use pliers to remove the carbon brush cap of the
carbon brushes. Take out the worn carbon brushes,
insert the new ones and replace the carbon brush cap in
reverse.
013588
Make sure to place the lead wire in opposite side of the
arm.
1. Rear cover
1
2. Screws
2
1. Spring
2
2. Recessed part
3. Arm
3
1. Carbon brush
cap
1
1
2
013577
Put the lead wires between the spacer and the side of
brush holder.
1
2
006304
Make sure that the carbon brush caps fit into the holes
in brush holders securely.
Reinstall the rear cover and tighten two screws securely.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Screw bits
•
Protector (white, blue, red)
•
Battery Protector for BL1415NA
•
Battery BL1415NA
•
Makita genuine charger
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
10
1. Lead wire
2. Spacer
1. Hole
2. Carbon brush
cap
or attachments
Only use accessory or
are