Zanussi ZDI22003XA Notice D'utilisation page 8

AIRDRY FUNCTION
AirDry improves the drying results with less energy
consumption.
While the drying phase operates, the
device opens the appliance door. The
door is then kept ajar.
By default, AirDry is activated with all programmes
excluding (if applicable), but it is possible to
deactivate it.
DEACTIVATING AIRDRY
Make sure the programme marker points at the
on/off indicator.
BEFORE FIRST USE
1. Make sure that the current level of the
water softener agrees with the hardness
of the water supply. If not, adjust the level
of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the appliance.
ADDING SALT
Before the first use, put one litre of water in the salt container.
CAUTION! Water and salt can come out of the salt container during filling. To prevent
corrosion, start a programme immediately after filling the salt container.
8
1. Press and hold
knob counterclockwise until the programme
marker is in position.
2. Release when the on/off indicator and
start to flash.
3. Turn the knob counterclockwise until the
programme marker is in
The indicator indicates the current setting. If
on = AirDry is on, if off = AirDry is off.
4. Press to activate or deactivate AirDry.
5. To confirm and save the setting, turn the knob
back to the position of the on/off indicator.
CAUTION! If children have access to
the appliance, it is advised to
deactivate AirDry as opening the door
may pose a danger.
Do not use detergent and do not load the
baskets.
After starting a programme, it may take up to 5
minutes for the appliance to recharge the resin in
the water softener. It seems that the appliance is
not working. The washing phase starts only after
this procedure is completed. The procedure is
repeated periodically.
and simultaneously turn the
position.