Publicité
Les langues disponibles
Les langues disponibles
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
•
The end indicator flashes 1 time inter-
mittently.
•
The
indicator flashes continuously.
The appliance does not drain the water.
•
The end indicator flashes 2 times inter-
mittently.
•
The
indicator flashes continuously.
The anti-flood device is on.
•
The end indicator flashes 3 times inter-
mittently.
•
The
indicator flashes continuously.
The appliance stops and starts more
times during operation.
The program lasts too long.
Small leak from the appliance door.
The appliance door is difficult to close.
Rattling/knocking sounds from inside the
appliance.
12
Possible cause and solution
•
Make sure that the mains plug is connected to the
mains socket.
•
Make sure that there is no damaged fuse in the fuse
box.
•
Make sure that the appliance door is closed.
•
Press
.
•
If the delay start is set, cancel the setting or wait for
the end of the countdown.
•
The appliance has started the procedure to re-
charge the resin inside the water softener. The dura-
tion of the procedure is approximately 5 minutes.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is
not too low. For this information, contact your local
water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clog-
ged.
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or
bends.
•
Close the water tap and contact an Authorised
Service Centre.
•
It is normal. It provides optimal cleaning results and
energy savings.
•
If the delayed start option is set, cancel the delay
setting or wait for the end of the countdown.
•
The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
•
The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
•
The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
•
Parts of the tableware are protruding from the bas-
kets.
•
The tableware is not properly arranged in the bas-
kets. Refer to basket loading leaflet.
•
Make sure that the spray arms can rotate freely.
Publicité
