Using The Screen On-Screen Display - Sony Trinitron GDM-200PS Mode D'emploi

4
Fine tuning the color temperature
Press the ¨./> buttons to select R (red), G (green), or B
(blue) and adjust by pressing the >?// buttons.
The "5000K," "6500K" or "9300K" disappears and the
new color settings are memorized for each of the three
color modes.
The color temperature modes change as follows:
5000Kn 1, 6500Kn 2, 9300Kn 3
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To reset, press the RESET button while the OSD is on. The
selected color temperature is reset to the factory settings.
Using the SCREEN On-screen
Display
COLOR
Adjust convergence settings to eliminate red or blue
1 6500K 9300K
shadows that may appear around objects on the screen.
R 76
G 50 Adjust the CANCEL MOIRE function to eliminate wavy or
B 50
elliptical lines that may appear on the screen.
Once CANCEL MOIRE is adjusted, it will be stored in
memory for the current input signal. All other adjustments
will be stored in memory for all input signals received.
1
2
3
Select
H CONVERGENCE
V CONVERGENCE
V CONVER TOP
V CONVER BOTTOM
Customizing Your Monitor
Press the MENU button.
The MENU OSD appears.
MENU
Press the ¨./> and >?// buttons to select "
SCREEN," and press the MENU button again.
The SCREEN OSD appears.
Press the ¨./> buttons to select the item you want
to adjust.
To
adjust the horizontal convergence
adjust the vertical convergence
TOP adjust the screen's upper vertical
convergence
BOT
adjust the screen's lower vertical
convergence
EN
SCREEN
TOP
BOT
26
H CONVERGENCE
(continued)
13