Troubleshooting; General - Yamaha MusicCast VINYL 500 Mode D'emploi

|
When necessary

Troubleshooting

Troubleshooting
If the unit stops operating correctly, check the following points.
If taking the appropriate action does not solve the problem, or if there is a problem not listed below, press the STANDBY/ON (power) button located on the unit's back
panel to turn off the power, disconnect the power cord, and contact your nearest authorized Yamaha dealer or service center.

General

Problem
Pressing STANDBY/ON (power)
does not turn on the power.
When you press STANDBY/ON
(power), the STANDBY/ON
(power) indicator flashes and
the power does not turn on.
Pressing SOURCE does not
switch the source.
The platter does not rotate.
No sound.
38
En
Cause
The AC adaptor has come unplugged from this unit's DC IN
jack or from the AC outlet, or is not firmly plugged in.
The protection circuit operated three times in succession.
The audio output select switch is set to PHONO OUT.
The belt is not correctly positioned on the platter and pulley,
or the belt has come off.
STANDBY/ON (power) is not on.
The head shell is not correctly attached to the tone arm.
The RCA stereo cable is not connected correctly.
The mute setting of the amplifier is on.
The audio output select switch of this unit is set incorrectly.
Action
Firmly plug the AC adaptor into this unit's DC IN jack and into
an AC outlet.
In order to protect the unit, the power will no longer turn on.
Contact a Yamaha service center to have the unit repaired.
Set the audio output select switch to LINE OUT.
Attach the belt correctly to the platter and the pulley.
Turn STANDBY/ON (power) on.
Attach the head shell correctly to the tone arm.
Connect the RCA stereo cable correctly.
Turn off the mute setting of the amplifier.
Set the audio output select switch correctly for the device
that is connected.
Reference
page
18
—
14
15
22
16
18
—
18