Detailed Settings; Making Settings Via Musiccast Controller; Setting The Sleep Timer; Enabling/Disabling Automatic Playback - Yamaha MusicCast VINYL 500 Mode D'emploi

Detailed settings

Making settings via MusicCast CONTROLLER

You can use MusicCast CONTROLLER to make settings for a variety of functions.

Setting the sleep timer

This function automatically sets this unit's power to standby mode after the
specified time has elapsed.
Settings:
Off (default), 30 Min., 60 Min., 90 Min., 120 Min.
NOTE

The sleep timer setting is canceled if you perform any of the following
actions.
- Set this units power to standby mode.
- Unplug this unit from the AC outlet.
- Switch the source to PHONO.

The sleep timer cannot be used if the source is set to PHONO.

Enabling/disabling automatic playback

This function specifies whether songs from the computer (server) will play
automatically when the source is switched to Server.
Settings
On (default): Automatic playback is enabled.
If the unit keeps a history of playback, the last item that was
played will be played again. If such an item no longer exists, the
unit will not play it.
Off: Automatic playback is disabled.
32
En

Enabling/disabling automatic standby

This function automatically sets the power to standby mode after the specified
time has elapsed without any playback or operation being performed.
Settings
Off: Automatic standby is disabled.
On: Automatic standby is enabled.
If this unit has not been playing for the last 20 minutes, or has not been
operated for the last eight hours, the power automatically switches to
standby mode.
Default
U.K., Europe and Korea models: On
Other models: Off
NOTE

Immediately before entering standby mode, the STANDBY/ON (power)
indicator flashes.