When Necessary; Updating The Firmware - Yamaha MusicCast VINYL 500 Mode D'emploi

When necessary

Updating the firmware

New firmware that provides additional features or product improvements is released as needed.
You can update the firmware using the MusicCast CONTROLLER that's installed on your mobile device.
When new firmware is available, the screen of MusicCast CONTROLLER shows the message "Update new firmware now?".
1
Tap "Yes".
Firmware update begins.
During the update, a progress bar is shown in the screen of MusicCast
CONTROLLER, and the SOURCE indicator of this unit flashes light blue.
When the update is successful, the screen of MusicCast CONTROLLER
indicates "Firmware update completed." and the SOURCE indicator of
this unit is lit light blue.
NOTICE

While the firmware is being updated, do not operate this unit or disconnect
the AC adaptor or the network cable.
34
En
NOTE

If you chose "Later", tap (Settings) in MusicCast CONTROLLER and
choose "New firmware is available". Update the firmware as directed by the
screen.

When new firmware is available, the SOURCE indicator also flashes orange
when the power of this unit is turned on.

If you're not using MusicCast CONTROLLER, the firmware update starts
when you hold down PLAY/STOP (play/stop) and press STANDBY/ON
(power) while this unit's power is in standby mode.

For more about the firmware, refer to the Yamaha website.