Precautions For Use; About The Power Cord Support Bracket; Note About Pinpoint Feet - Teac ESOTERIC Grandioso M1 Mode D'emploi

Precautions for use

o This unit is very heavy, so take care to avoid injury during installation.
o Do not install this unit in a location that could become hot. This
includes places that are exposed to direct sunlight or near a radiator,
heater, stove or other heating equipment. Moreover, do not place it
on top of another amplifier or equipment that generates heat.
o Avoid locations that are subject to vibrations or exposed to exces-
sive dust, cold or moisture.
o This unit generates more heat than ordinary power amplifiers.
When installing it, install it by itself at least 20 cm (8") from walls
and other equipment.
If you put it in a rack, take precautions to prevent overheating by
using a rack with ventilation openings, for example, and leaving at
least 20 cm (8") open above the top of the unit and at least 10 cm
(4") open behind the unit.
o Do not install it face up or on its side.
o Place the unit in a stable location near the audio system that you
will use with it.
o DO NOT place anything, not even CDs, CD-Rs, LP records or cas-
sette tapes, on top of the unit. Doing so could cause damage.
o Do not put cloth on top of the unit or place the unit on top of
bedding or thick carpet. Doing so could cause the unit to over-
heat or damage it.
o Supply voltage to the unit that matches the voltage indicated on
the rear panel. If you are in any doubt regarding this matter, con-
sult an electrician.
o Do not move the unit during use.
o Do not open the body of the unit as doing so might result in
damage to the circuitry or cause electric shock. If a foreign object
should get into the unit, contact your dealer.
o When removing the power plug from an outlet, always pull
directly on the plug. Never pull on the cord itself.
o If a TV is turned on while the unit is on, static might appear on the
TV screen depending on the characteristics of the TV broadcast
signal. This is not a malfunction of the unit nor of the TV. If this
occurs, turn the unit off.

About the power cord support bracket

This unit includes a bracket to support heavy power cords, such as
the ESOTERIC 7N-PC9500 MEXCEL and 7N-PC7500 and 7N-PC5500
power cords.
Align it with the power cord being used and attach it, tightening the
screws securely.
Power inlet
Screw

Note about pinpoint feet

High-precision metal pinpoint feet are attached firmly to the bottom
plate of this unit.
The stands for these feet are loose, but when the unit is placed in
position, it is supported by these pinpoint feet, which will effectively
disperse vibrations.
Chassis
Foot-stand
(metal)
o Apply the included felt pads to the bottoms of the foot-stands to
avoid scratching the surface where the unit is placed.
Power cord
Bracket
Pinpoint foot
(metal)
Screws that attach
foot-stand
7 7