Dust Cover Installation; Opening And Closing The Turntable Cover; Notes About Record Styluses - THOMSON TT600BT Mode D'emploi

Dust Cover installation

Attaching the turntable cover
TURNTABLE COVER
MAIN UNIT
• Insert the hinges completely into the hinge holders at the left and right ends of the back of the main
unit.
• Align the tops of the hinges with the turntable cover hinge holders and insert them.
Removing the dust cover
• Hold both edges of the turntable cover and lift it slowly to remove it along with the hinges from the
unit. Then, remove the hinges from the turntable cover.

Opening and closing the turntable cover

OPEN
Opening
• Hold the front edge of the turntable cover and gently lift it open completely until it stops.
• The turntable cover will stay open in this position.
Closing
• Gently lower the turntable cover until it is closed.
• Be careful not to pinch your hand when opening and closing the turntable cover.

Notes about record styluses

• Record styluses are precision parts, so handle them carefully to avoid bending or damaging their
tips. If a stylus becomes bent or damaged, it might not be able to follow the audio groove precisely
and could damage records or cause another malfunction.
• If a stylus becomes dirty, use a commercially available stylus cleaner or similar product to clean it.
• Do not rub the stylus tip forcefully with anything hard. Do not wipe the stylus with thinner or other
chemicals. Doing so could harm it.
HINGE
- EN 5 -