Mitsubishi Electric MSZ-AP15VG Notice D'utilisation page 8

● OPERATING INSTRUCTIONS ●
C
LEANING
Instructions:
• Switch off the power supply or turn off the breaker before cleaning.
• Be careful not to touch the metal parts with your hands.
• Do not use benzine, thinner, polishing powder, or insecticide.
• Use only diluted neutral detergents.
• Do not use a scrubbing brush, a hard sponge, or the like.
EN
Air fi lter
Clean every 2 weeks
•
• Remove dirt by a vacuum cleaner, or rinse with water.
• After washing with water, dry it well in shade.
Front panel
1. Lift the front panel until a "click" is heard.
2. Hold the hinges and pull to remove as shown in the illustration above.
• Wipe with a soft dry cloth or rinse it with water.
• Do not soak it in water for more than two hours.
• Dry it well in shade.
3. Install the front panel by following the removal
procedure in reverse. Close the front panel
securely and press the positions indicated by
the arrows.
W
i-Fi INTERFACE SETTING UP (VGK type only)
This Wi-Fi interface, communicates the status information and controls the commands from the MELCloud by connecting to the indoor unit.
Wi-Fi interface
EN-6
Hinge
Hole
Front panel
• Do not soak or rinse the horizontal vane.
• Do not use water hotter than 50°C.
• Do not expose parts to direct sunlight, heat, or fi re to dry.
• Do not apply excessive force on the fan as it may cause cracks or breakage.
Important
• Clean the fi lters regularly for best performance and to
reduce power consumption.
• Dirty fi lters cause condensation in the air conditioner
which will contribute to the growth of fungi such as
mold. It is therefore recommended to clean air fi lters
every 2 weeks.
Note:
• Set up a connection between the Wi-Fi interface and the Router. Refer to the
SETUP MANUAL and SETUP QUICK REFERENCE GUIDE provided with
the unit.
• For SETUP MANUAL, please go to the website below.
http://www.melcloud.com/Support
• For MELCloud User Manual, please go to the website below.
http://www.melcloud.com/Support