Mitsubishi Electric MSZ-AP15VG Notice D'utilisation page 6

● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART
Indoor unit
Front
panel
Air fi lter
Horizontal vane
Air outlet
Heat exchanger
EN
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or
turn the breaker on.
Installing the remote controller batteries
4.
Press RESET.
1.
Remove the front lid.
EN-4
Air inlet
Wi-Fi interface
Emergency
Spec name
operation switch *2
plate *1
Operation
indicator lamp
Remote control
receiving section
2.
Insert the negative
pole of AAA
alkaline batteries fi rst.
3.
Install the front lid.
Outdoor unit
Outdoor units may be different in appearance.
*1 The manufacturing year and month are indicated on the spec name plate.
When the remote controller cannot be used...
*2
Emergency operation can be activated by pressing the emergency operation switch (E.O. SW)
on the indoor unit.
Each time the E.O. SW is pressed, the operation changes in the following order:
Emergency Emergency
COOL HEAT Stop
Setting current time
1.
Press CLOCK.
4.
Press CLOCK again.
Air inlet (back and side)
Spec name plate *1
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
Set temperature : 24°C
: Lit
Fan speed : Medium
: Not lit
Horizontal vane : Auto
3.
Press the DAY button
to set the day.
2.
Press either the TIME button
or the TIMER buttons to set
the time.
Each press changes the clock
1 minute forward/backward (10
minutes when pressed longer).