Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Menu Item
Description
REAR-SP
Select when there is a full-range speaker connected to the rear
speaker output leads.
[FUL]
[SW]
Select when there is a subwoofer connected directly to the rear
speaker output leads without any auxiliary amplifier.
SP-P/O MODE
Select when there is a full-range speaker connected to the rear
speaker output leads and there is a subwoofer connected to the
[REAR/SUB.W]
RCA output.
[SUB.W/SUB.W]
Select when there is a passive subwoofer connected directly to
the rear speaker output leads and there is a subwoofer
connected to the RCA output.
[REAR/REAR]
Select when there are full-range speakers connected to the rear
speaker output leads and RCA output. If there is a full-range
speaker connected to the rear speaker output leads, and the
RCA output is not used, you may select either [REAR/SUB.W] or
[REAR/REAR].
S/W UPDATE
Select to update the unit to the latest Bluetooth software. For
details on Bluetooth software and updating, visit our website.
SXM RESET
Select to initialize the SiriusXM settings.
[YES], [CANCEL]
SYSTEM RESET
Select [YES] to initialize the unit settings. The unit will be
restarted automatically.
[YES], [CANCEL]
(Some of the settings will be retained even after resetting the
unit, such as Bluetooth pairing information, etc.)
Radio
The tuner frequencies on this unit are allocated for use in North America. Use in other
areas may result in poor reception.
Receiving preset stations
1
Press SRC/OFF to select [RADIO].
2
Press BAND/
to select the band from [FM1], [FM2], [FM3] or [AM].
3
Press a number button (1/
to 6/
).
TIP
The
/
buttons can be also used to select a preset station when [SEEK] is set to [PCH] in the
FUNCTION settings (page 15).
Best stations memory (BSM)
The six strongest stations are stored on the number buttons (1/
1
After selecting the band, press the M.C. dial to display the main menu.
2
Turn the M.C. dial to select [FUNCTION], then press to confirm.
3
Turn the M.C. dial to select [BSM], then press to confirm.
To seek a station manually
1
After selecting the band, press
Press and hold
/
then release to seek an available station. Scanning stops
when the unit receives a station. To cancel seek tuning, press
NOTE
[SEEK] needs to be set to [MAN] in the FUNCTION settings (page 15).
To store stations manually
1
While receiving the station you want to store, press and hold one of the number
buttons (1/
to 6/
) until it stops flashing.
to 6/
).
/
to select a station.
/
.
7
En
Publicité
Chapitres
Table des Matières
