Pioneer FH-X820BS Mode D'emploi page 21

DIN Rear-mount
1
Determine the appropriate position
where the holes on the bracket and
the side of the unit match.
2
Tighten the screws on each side.
Screw
Mounting bracket
Dashboard or console
• Use either truss (5 mm × 8 mm) or
flush surface (5 mm × 9 mm) screws,
depending on the bracket screw
holes.
Installing the microphone
(Only for FH-X820BS/X720BT/X721BT)
The microphone should be placed directly
in front of the driver at a suitable distance
to pick up their voice clearly.
CAUTION
It is extremely dangerous to allow the
microphone lead to become wound
around the steering column or shift lever.
Be sure to install the microphone in such a
way that it will not obstruct driving. It is
recommended to use the clamps (sold
separately) to arrange the lead.
To install on the sun visor
1
Fit the microphone lead into the
groove.
Microphone lead
Groove
2
Install the microphone clip on the sun
visor.
Lowering the sun visor reduces the
voice recognition rate.
Microphone clip
To install on the steering
column
1
Slide the microphone base to detach it
from the microphone clip.
Microphone
Microphone clip
Microphone base
2
Install the microphone on the rear side
of the steering column.
Double-sided tape
21
En