Télécharger Imprimer la page

ABAC TOOL KIT Notice D'utilisation page 71

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 68
EN
IMPACT WRENCH KIT
Before connecting accessories make sure the compressor is shut down.
ACCESSORIES
Only use accessories and consumables that are designed for the use with this tool.
Select the best available inserted/mounted accessories/consumables for the lowest possible noise level and vibration.
Replace them in case of an increased noise level and/or vibration.
Make sure that the inserted/mounted tool/accessory is properly held by the retainer and make sure that the retainer
is in good condition. Never use the tool without a retainer as this may cause high speed projectiles.
Only use sharp chisels, as blunt chisels require excessive pressure and can break.
Never cool down a hot tool/accessory as this may influence the hardness causing dangerous circumstances.
Use the inserted/mounted accessory/tool according the manufacturer specifications.
Never use a chisel as lever as this can cause brakeage.
USING A PNEUMATIC TOOL
DO NOT operate the tool freely, It must always be in contact with the work surface. Failure to do so can cause
Retainer, Cylinder or housing failure which may result in injury to the operator and will invalidate warranty.
If a chisel is released by the retainer whilst in use, stop the tool immediately and re insert the chisel.
Before start using the tool, make sure that you are familiar with the workplace and surrounding area.
Always obey the safety regulations for the work area you are working in.
Hold the tool always firmly with both hands.
During operating the tool, the operator may be exposed to hazards as crushing, impacts, heat, vibration, cuts,
abrasions, etc: Wear suitable gloves.
Any person handling the tool must be able to handle the size, weight and power of the tool.
Always be prepared for normal/abnormal movements/forces generated by the tool.
Keep your body in balance, place your feet safe and secure.
In case of interruption of the air supply, release the lever/trigger.
When using a power tool, you may experience discomfort in your hands, arms, shoulders, neck and other parts of
your body.
If you experience symptoms such as persistent or recurring discomfort, pain, throbbing, aching, tingling, numbness,
burning sensation, or stiffness: Do not ignore these warning signs. Stop using the tool, tell your employer and
consult a qualified health professional.
USING THE IMPACT WRENCH (1)
• Before operating the equipment, put some oil drops (D) in the air inlet opening (F) of the pneumatic tool.
• In case connection (E) is already assembled on the inlet opening (F), put some oil drops (D) on it (E).
• Choose the correct impact socket (C) from the kit as needed and mount it onto the anvil (A).
• Connect air supply hose to E.
• Place the socket over the nut to be removed or installed.
71

Publicité

loading