Bosch Uneo Notice Originale page 12

OBJ_BUCH-1695-002.book Page 12 Tuesday, April 2, 2013 10:59 AM
12 | English
Symbol Meaning
U Rated voltage
E Impact energy per stroke according to
EPTA-Procedure 05/2009
n No-load speed
0
M Maximum torque according to
ISO 5393
Wood
Steel
Concrete
Brickwork
Ø Drilling diameter, max.
Ø Max. screw dia.
Weight according to EPTA-Procedure
01/2003
L Sound power level
wA
L Sound pressure level
pA
a Vibration total value
h
K Uncertainty
Delivery Scope
Cordless Rotary Hammer.
Application tools and other accessories shown or described
are not part of the standard delivery scope.
A complete overview of accessories can be found in our ac-
cessories program.
Intended Use
The power tool is intended for hammer drilling in concrete,
brick and stone. It is also suitable for drilling without impact in
wood and metal, as well as for screwdriving.
Technical Data
The technical data of the machine are listed in the table on
page 87.
Mounting and Operation
The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Action
Removing the battery
2 609 006 431 | (2.4.13)
Declaration of Conformity
We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with the fol-
lowing standards or standardization documents: EN 60745
according to the provisions of the directives 2011/65/EU,
2004/108/EC, 2006/42/EC.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Helmut Heinzelmann
Senior Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 02.04.2013
Noise/Vibration Information
The measured values of the machine are listed in the table on
page 87.
Noise and vibrational values (vector sum of three directions)
determined according to EN 60745.
The vibration emission level given in this information sheet
has been measured in accordance with a standardised test
given in EN 60745 and may be used to compare one tool with
another. It may be used for a preliminary assessment of expo-
sure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or poorly maintained,
the vibration emission may differ. This may significantly in-
crease the exposure level over the total working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working pe-
riod.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep hands warm, organise work patterns.
Figure Please observe
1
Page
88
Bosch Power Tools