User Guide - INFOSEC UPS SYSTEM 650 XP SoHo Notice D'utilisation

To ensure this product is correctly installed and used in the right way, we highly advise you
to read this user guide very carefully.
1 . I N T R O D U C T I O N
This UPS range is specially designed for multimedia Personal Computers. Its light weight
and compact design suit limited working environments. The XP range of UPS is equipped
with boost and buck AVR to stabilize input voltage. It also has a built-in DC start function.
This function enables the UPS to be started up without an AC power supply. The main
features of XP UPS are listed below.
2 . M A I N C H A R A C T E R I S T I C S
Microprocessor control guarantees high reliability
Equipped with boost and buck AVR
Green Power Function for energy saving
DC Start Function
Auto restart during AC recovery
Compact size, lightweight
Provides modem / phone line surge protection
3 . S A F E T Y I N S T R U C T I O N S – S e c u r i t y
The UPS unit uses potentially hazardous voltages. Do not take this equipment apart. It
does not contain accessible components that can be repaired by users.
All repairs should be performed by qualified technicians only.
The UPS has its own internal power supply (battery). There is a risk that output sockets
may still be live after the UPS has been disconnected from the mains power supply.
The UPS has been designed for power computers. It should not be used with power
electronic equipment with inductive loads such as motors or fluorescent lights.
Do not connect any non-computer units to the UPS, such as medical equipment for
artificial life handling, microwave, vacuum cleaner, etc.
Laser printers should not be connected to the UPS as they consume too much power.
Make sure that the power supply required does not exceed the capacity of the UPS. We
recommend using an optimum power load equivalent to half or one third of the nominal
power for longer backup time and battery life.
Do not leave any container with liquid on the UPS or close to it.
Unplug the UPS before proceeding to cleaning it. Do not directly apply any liquid
detergent or sprays.
The UPS should not be used in a damp place, nor exposed to direct sunlight or heat-
emitting sources. Do not cover the ventilation slots.
In case of emergency, switch the UPS to the "OFF" position and then unplug the power
cord from the power socket to disable the UPS completely.
Should the UPS fail to operate correctly, please refer to section 10: Trouble Shooting.
2
INFOSEC UPS SYSTEM - 4, rue de la Rigotière – 44700 Orvault – FRANCE - www.infosec.fr
Hot Line : tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 09 05 04 206 02

User guide