Whirlpool W11183136A Instructions Pour L'installation page 26

8.
Reinstall hinge assembly on opposite side
Flip over the inner door to the left. Using a T20
reinstall the hinge assembly on the opposite side from which
it was removed.
DOORS WITH ELECTRICAL WIRING:
9.
Remove rotating assembly
Lift off inner door assembly. Using a Phillips screwdriver,
remove the two screws securing the rotating assembly
to the door.
26
10.
screwdriver,
®
Reposition rotating assembly and tubing 180 ° to opposite side
of the door.
11.
Rotate bottom of assembly 180° towards you and secure
assembly with the two screws removed earlier, using a Phillips
screwdriver. Press tubing into indents.
IMPORTANT: Make sure to swing hinge down in front of
rotating assembly (see Step 12).
Reposition rotating assembly
and tubing
Rotate assembly bottom and fasten
in place
Press tubing
into indents.