Publicité
Les langues disponibles
Les langues disponibles
To fill the appliance: Open one of the hot water draw-off
points connected to the wall boiler. Then open the tap in
the inlet combination. When the water starts to flow out of
the draw-off point the wall boiler has been filled. The device
only switches on again if the temperature falls below this
setting. (See troubleshooting)
When filling for the first time, the hot water valve in the low-pressure tap fitting must
be open so that water can flow into the device. If the device is not filled with water be-
forehand during installation, the automatic safety device will activate and switch off the
device. (See troubleshooting instructions on how to act in the event of a fault.)
Temperature setting
Turn the on/off button to switch the wall boiler on. The 'ON' light comes on.
Turn the button on the right to set the required temperature. The 'HEATING' light will
come on until the water has been heated.
Stand
Description
Water is not heated
LOW
Water is moderately heated
E
Energy-saving position
HIGH
Water is heated to maximum temperature
Usage and maintenance
Please refer to the previous section for details of the thermostat settings. We recom-
mend you use position „E" as this guarantees maximum energy efficiency and the low-
est lime scale building. By maintaining the water temperature at approximately 55°C;
furthermore lime scale build-up and heat loss are much lower than at higher tempera-
tures.
As the water that is used for washing the dishes has a temperature of approximately 45
to 50°C, cold water has to be mixed in to reach this temperature. At a water tempera-
ture of 60°C, you will be able to draw off about 14 litres of 45°C.
Operation of the device is indicated by the indicator light, which lights up when the de-
vice is on and extinguishes when the set temperature is reached or the device is turned
off.
DE GB NL FR
19
Publicité
