Publicité
Les langues disponibles
Les langues disponibles
DE GB NL FR
Frost
If there is the risk of frost in a room, the device should not
be installed in this room. If, despite this advice, the device is
installed in a room where there is a risk of frost, the device
should be emptied before the risk arises.
Legend
Figure A
Number
1
2
3
4
5
6
7
8
9
10
11
12
13
A safety unit must be used for installation.
Placement on the wall
Figure B
• The appliance must be fitted on a stable and solid wall. The wall must be able to at
least bear the total weight of a full wall boiler.
• Determine a suitable place for the wall boiler. Insert the cotter bolts in the wall using a
suitable tool. Make sure that the cotter bolt hooks are facing upwards.
IMPORTANT: In the unlikely event that the device is
connected to the mains power supply without being
filled with water, or if for some reason the device
switches off after a short while, please disconnect
the plug from the wall socket to allow the device to
cool down.
Connection to the water supply
Figure A
• The water connections are 1/2".
• Connect the cold water supply to (11). Fit an inlet combination in between.
• Always use the rubber rings with filter supplied to prevent leaks.
• Connect (6) the piping for the hot water.
16
Description
Housing
Thermometer
Inner container
Insulation
Heating element
Hot water outlet
On/off button
Indicator when appliance heated up
Indicator when appliance is connected to the mains
Temperature controller
Cold water inlet
Anode
Plug
Publicité
