Philips Lumea Guide De L'utilisateur page 18

18
English
C Treatment
IMPORTANT: First finish section A (Remove hair & clean your skin) and B
(Test skin 24 hrs before treatment).
1 Connect the power adapter to the device and plug into a power outlet.
2 Press the on/off button
3 Choose the setting you selected after the skin test (section B, step 9).
4 Press the device firmly onto your skin and hold it in place. The 'READY to
flash' light should light up white.
5 Press the flash button to release a flash on your skin. The flash treats the
skin in that spot.
The device makes a soft popping sound. The flash gives you a warm
sensation.
After each flash, it takes up to 3.5 seconds until the device is ready to
flash again. You can release a flash when the 'READY to flash' light lights
up white.
6 Move the device to the next spot, close to, but not overlapping the
previous spot. Make sure that you flash the same area only once.
7 Continue until you have treated the full area. There are two treatment
modes (see 'Two treatment modes: Stamp & Flash and Slide & Flash').
8 Switch off the device when you finished the treatment.
9 Remove hair before every next treatment, as long as hair is still visible.
to turn on the device.