baracuda G3 Guide Du Propriétaire page 8

Clearing the Diaphragm
Use the Quick Access Cassette system to quickly
clear the diaphragm or check it for damage.
To remove:
1. Unscrew the cassette and pull it out
of the cleaner.
2. Loosen the cassette chamber; pull the inner
pipe and diaphragm from the bottom of the
cassette chamber.
3. Pull off the diaphragm.
Inspect it for debris or wear, and rinse it
thoroughly with water. Replace if necessary.
To install:
1. Verify that the retaining ring is on the diaphragm.
2. Push diaphragm onto inner pipe.
3. Pull inner pipe and diaphragm through bottom of
cassette chamber until the diaphragm seats against
the lip.
4. Tighten cassette outer pipe and replace cassette body.
Replacing the Foot Pad
The foot pad should be replaced when the depths of the channels between the treads are 1/8" or less
To remove:
Press down on the locking tab while pulling
the foot flange toward you and up.
Tab
Storage and Winterizing
Never coil the hose. Always store G3 out of direct sunlight. When storing for the winter, drain all water
from the cleaner. Remove all connectors and adapters from the dedicated suction line or skimmer. Store
finned disc flat, and hose sections disconnected, drained and straight.
8 8
Retaining
Ring
Diaphragm
Cassette
Chamber
To install:
Insert foot flange into body, push down and lock
into place.
Cassette
Chamber
Inner Pipe