Makita DCL181F Manuel D'instruction page 8

3. Twist high performance filter in direction of arrow
to unfasten securing lip from cleaner unit and then pull
off the filter.
► 1 . Securing lip
4. Clean out the fine dust and lightly tap to dislodge
dust from high performance filter.
Reassembly
Reassembly for normal filter
1. Put on filter until it is fully in position on the cleaner
unit.
1
► 1 . Filter
1
► 1 . Filter
NOTE: Make sure filter is put on straight without
being peeled back. If filter is put on incorrectly as
shown in diagram, dust will get into motor housing,
and cause motor failure.
2.
prefilter so that securing lip is firmly locked into cleaner
unit.
1
► 1 . Prefilter
3.
mark on handle and then firmly twist capsule in direction
of arrow until it is secured.
► 1 . O Mark
8 ENGLISH
Connect prefilter. At this time, make sure to twist
1
Connect capsule. Align O mark on capsule with O
1