E20: Air Conditioning Reservoir Full - Hapro Luxura X5 Mode D'emploi

Messages
Malfunction
When a malfunction occurs, the buttons
standby. The machine also produces 3 rapid beeps once every minute. Press all four of the
buttons at the same time to see which fault or faults have occurred.
If a critical fault occurs, the malfunction screen appears automatically. The text 'Malfunction'
appears at the top of the screen, and the fault code and an explanation appear at the
bottom. Use the and buttons to view the various fault messages. For faults E18, E19,
E20 and E21 you can exit the malfunction screen with the
Critical errors:
E1 = Internal timer has a defect
E2 = Fan in bottom tray has a defect
E3 = Communication error between relay and switch part
E6 = Unknown phase
E7 = Relay failure
E9 = Maximum temperature bench
E10 = Maximum temperature canopy
E11 = Communication error with fan board
Note:
When one of the above-mentioned critical faults appears on the display, you should no longer use the sunbed and the plug should be removed from the
mains outlet. Contact your dealer.
If one of the other faults occurs, the machine will still function, but not all the functions will be fully available. During fault E18 and E19 the machine cooling
will run at maximum throughout the entire session. To correct this, contact your dealer.

E20: Air conditioning reservoir full

Check whether the reservoir for the air conditioning is full. If the reservoir is full, you should empty the reservoir (see section 'Emptying air conditioning
reservoir' in this manual). The fault message disappears after several seconds. If the fault message does not disappear, contact your dealer.
E21: Cleaning the air conditioning
The air conditioning must be thoroughly cleaned every 6 months. If the air conditioning has not been cleaned within the past 6 months, fault message 'E21:
Clean the air conditioning' will appear. You must thoroughly clean the air conditioning. After it has been cleaned, you must reset the 'Airco service date' . For
more information, consult the 'Cleaning' section in this manual.
Note:
When one of the above-mentioned fault messages appears on the display, you should no longer use the sunbed and the plug
should be removed from the mains outlet. Contact your dealer.
, , and O ash when the machine is in
or button.
E3 = Communication fault between the
I/O controller and switch board.
Errors:
E18 = Communicatiestoring temperatuursensor bank
E19 = Communication error with temperature sensor canopy
E20 = Airconditioning reservoir full
E21 = Clean airconditioning
Error
11