Installation - AEG A71100TSW0 Notice D'utilisation

28 www.aeg.com
Problem
The appliance does
not cool at all
Green indicator
flashing
8.1 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".

9. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor (garage or cellar)
also, but for optimum performance in-
stall this appliance at a location where
the ambient temperature corresponds to
9.2 Levelling
Possible cause
Plug is not connected to
the mains socket properly
There is no voltage in the
mains socket (try to con-
nect another appliance
into it)
The appliance is not
switched on
Temperature Regulator is
not on
Temperature sensor
problem
3.
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
SN
N
ST
T
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.
Solution
Connect the mains plug
properly
Call an electrician
Switch on the appliance
Check the Temperature
Regulator
Call the service personnel
If necessary, replace the defective
door gaskets. Contact the Service
Center.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C