Installation; Pre-Assembly Of The Combination Oven; Parts Provided; Installation With The Speed Microwave Oven - Bosch 500 Série Mode D'emploi

Installation

Pre-Assembly of the
Combination Oven
Combination ovens require the units be assembled
together prior to installing the combination unit into the wall
cabinet.
Note: The installation procedures differ betweenthe speed
microwave oven and steam convection convectionoven
combination units. The parts contained in the square tube
parts box are common to both installations.

Parts Provided

Universal connector
bracket (2)
(in parts box on top of
oven)
Screws (16)
(in red bag, inside parts
box on top of oven)
Oven Mounting Screws
8 screws are included to
secure the oven trim to the
cabinet. The screws are
located in a small plastic
bag affixed to the literature
pack bag.
Trim Piece
(in plastic bag on top of
oven)
Installation with the Speed Microwave
Oven
Note: Do not place the oven into the wall cabinet until after
mounting the speed microwave oven on it using the univer-
sal connector brackets.
9001080875 Rev A
1. Install both universal connector brackets on top of the
lower oven using six of the screws provided. Tighten
screws securely, but do not overtighten.
Note: The universal connector brackets are interchange-
able for the left and right sides of the oven. Be sure the
taller vertical edge of the bracket is positioned to the out-
side of the oven.
Top View of Standard Wall Oven
2. Install the decorative trim.
Position the decorative trim
piece so the flanges with
the holes in them face to
the rear of the oven.
Align the outer flanges with
the outside of the universal
brackets. Fasten with 1
screw each into the end
hole of the universal
bracket. Tighten screws
securely, but do not
overtighten.
English 7