Instructions For Electrical Connection; Cables, Extensions And Plugs - Kunzle & Tasin Bona Belt UX Manuel D'utilisation Et De Maintenance

Commencing Operation (Cont.)
Instructions for assembly following transportation (cont.)
7.
Fit the suction pipe (A) and drum control rod (B).
8. 9.
Lift the drum with the lever (A). Connect the power supply cable
to the machine and power supply.

Instructions for electrical connection

This machine only operates with the voltage and frequency
shown on the machine data plate. Before connecting the cable
to the power supply ensure the correct voltage and frequency
are available.
14
Bona Belt UX Manual
DO NOT expose the machine to rain. This machine is intended
for dry use only. Keep the machine in a dry building and
DO NOT use it in damp or wet places.If the machine is not
connected correctly to the electricity network, death due to
electrocution may occur.
Commencing Operation (Cont.)
Instructions for electrical connection (cont.)
If the machine is not connected correctly to the electricity
network, death due to electrocution may occur. To prevent
electric shocks always use a grounded three wire electrical
system. For maximum protection against electric shocks use a
circuit protected with a differential cut-out switch.
Tampering with the grounding plug in any way may result in
death from electrocution. DO NOT cut, remove or break the
grounding plug. If the socket does not match the plug consult
a qualified electrician.

Cables, extensions and plugs

Only use approved cables. The maximum recommended cable length is 10 m; for greater lengths use cables
with a larger cross-section.
Using the machine with unsuitable and/or excessively long
cables may cause injury or damage to people or objects.
MACHINE WITH 230 V~50 Hz SINGLE PHASE MOTOR 2.2 kW
For machines with a 230 V~50 Hz motor (EU), a HO5VV-F-3x2.5 mm
along with an approved SCHUKO 2P+E 16 A 200÷250 V plug.
MACHINE WITH 230 V~50 Hz SINGLE PHASE MOTOR 3.0 kW
For machines with a 230 V~50 Hz motor (EU), a HO5VV-F-3x2.5 mm
along with an approved 2P+E CE 32 A 200÷250 V plug.
MACHINE WITH 230 V~50 Hz SINGLE PHASE MOTOR 3.7 kW
For machines with a 230 V~50 Hz motor (EU), a HO5VV-F-3x2.5 mm
along with an approved 2P+E CE 32 A 200÷250 V plug.
Bona Belt UX Manual
Do not use the machine if the switch malfunctions.
If the machine is used with a damaged plug or power supply
cable, death may occur from electrocution. If cables or plugs
are worn or damaged in any way, have them replaced by the
manufacturer or certified machine repair center in order to
prevent risks to safety.
The machine must never be moved using its cable and the
cable must never be pulled when disconnecting from the
socket.
Keep the cable away from sources of heat, oil and sharp
edges.
2 HAR-approved power supply cable must be used
HAR-approved power supply cable must be used
2
2 HAR-approved power supply cable must be used
EN
15