Yakima Raptor Aero Mode D'emploi page 3

SQUARE BARS ONLY:
7
Loosen the tabs
by bending them
repeatedly.
9
INSTALL THE RED KNOB.
• Choose access from
passenger or driver side.
• Red knob should face you
when the Raptor Aero is
attached to wheel tray.
• Place the Guide Plug
10
into the hole on one
side of the jaws.
• Slide the red knob's bolt threads
through the guide plug.
13
Tighten knob
completely until
threaded end is
exposed.
SKS® LOCK CORES ARE OPTIONAL.
To install SKS® Lock Cores, refer to lock instructions.
Instruction #1033402B - Page 3 of 12
ROUND OR SQUARE CROSSBARS: Install the SnapArounds™.
DO NOT INSTALL Universal MightyMounts™ on round or square bars!
Remove the tabs with
scissors or pliers.
threaded
11
• Place spring between guide
plug and threaded plug.
• Slide knob through spring
and into threaded plug.
14
A coin or a key
added leverage.
JAW ASSEMBLY
jaws
plug
• Insert the Threaded Plug
into the other hole.
Slide the "E"clip
into groove on end.
may provide
8
ROUND AND SQUARE BARS:
Attach 2
SnapArounds™
on the front
crossbar, and 1 on
the rear crossbar.
guide
plug
Turn the red knob
clockwise to engage
the threaded plug.
15
NOTE: If you are not
using a lock, leave
the plug in place.
12
Open red knob
completely.