Ec Declaration Of Conformity; Machine Characteristics; Machine Parts And Controls - Baier BDB 819 Traduction Du Mode D'emploi Original

EN
3.2

EC Declaration of Conformity

We herewith declare, with sole responsibil-
ity, that this product conforms to the follow-
ing standards or normative documents:
EN60745-1:2009+A11:2010
EN61029-2-6:2010
EN55014-1:2006+A1:2009+A2:2011
EN55014-2:2015
EN61000-3-2:2014
EN61000-3-3:2013
In accordance with the provisions of the Di-
2006/42/EC (Machinery Directive)
2011/65/EU (RoHS Directive)
in conjunction with the safety instructions
documented in the instruction manual and
the specified intended use.
The head of development is authorised to write the
technical documents.
These are available from:
Maschinenfabrik OTTO BAIER GmbH,
Heckenwiesen 26,
71679 Asperg
Germany
Thomas Schwab
Managing Director
Gasper, 19.02.2018
3.3

Machine characteristics

The machines are equipped with specially
developed electronics with soft start. It monitors
the speed and the green / red indicator lights
(items 1 and 2, see Figure
most favourable work progress and therefore tool-
protecting working conditions.
Visual display
Green: Speed for optimum drilling performance
Green / red: Speed within the limit range
Red: Speed too low – stopping
If this warning signal is ignored, i.e. the feed is not
reduced, the electronics switch off on overload.
After the wet diamond core drill bit has stopped,
remove it from the drill hole. The machine can be
immediately restarted.
| 40 |
rectives
Robert Pichl
Head of development
1 ) help to achieve the
The wet diamond drill is equipped with a personal
protection switch (PRCD).
3.4

Machine parts and controls

Wet diamond drill
1
1 Green LED
2 Red LED
3 Lock for ON / OFF switch
4 ON / OFF switch
5 Handle
6 Connection cable
7 Gear change knob (1st, 2nd and 3rd gear)
8 Additional handle (can be mounted for left and
right-handed persons)
9 Open-ended spanner SW36
10 Open-ended spanner SW41
11 Personal protection switch PRCD
12 Water connection with stopcock and Gardena
coupling
13 Internal thread G½"
14 External thread 1¼" UNC
15 Output shaft
16 Spirit level
BST 819, BST 200 drill stands
2
(optional accessories, see "Tools and Accessories"
on page 48 or BAIER catalogue)
The drill stand is intended for holding diamond drills
with a maximum power of 2.2 kW in conjunction
with wet diamond core drill bits in mineral materials
such as concrete, reinforced concrete or masonry.
The largest allowable diameter drilled is 200 mm.
Other units, which exceed these values, may not
be used. The drill stand can be attached to the floor
and to the wall with the help of plugs or anchors,
vacuum.
1 Sliding element
2 Nut, top tilt adjustment
3 Pinion shaft
4 Tube lock with clip
5 Feed crank handle
6 Tapered shaft
7 Spirit level
8 Drill stand plate
9 Nut, bottom tilt adjustment
10 Cap nut (4x)
11 Cheese head screws, bottom tilt adjustment
12 Cheese head screws, machine collar
13 Machine collar
14 Circlip