Hazards When Using And Handling The Drill Stand; 2.6.7 Service / Maintenance / Repair - Baier BDB 819 Traduction Du Mode D'emploi Original

NOTE
The above safety instruction only applies if it is
planned to use the tool with a vacuum plate.
•
Avoid unnecessary noise emissions.
•
Note and follow the safety and work
instructions for the accessories used.
2.6.6 Hazards when using and
handling the drill stand
•
Before mounting the drill or drive unit, set
up the drill stand correctly in accordance
with these instructions.
Correct assembly is important to ensure proper,
faultless functioning of the stand.
•
Fasten the drill stand securely on a firm, flat
surface using the specified and undamaged
installation materials.
If the drill stand can slip or wobble, the drill or
drive unit cannot be guided uniformly and safely.
•
Disconnect the plug of the drill or drive unit
from the socket before mounting the drill or
drive unit on the drill stand, make any unit
settings or change accessory parts.
Unintentional starting of drills or drive units
causes accidents.
•
Fix the drill or drive unit securely onto the
drill stand as specified before starting work.
Slipping of the drill or drive unit on the drill stand
can cause loss of control and injuries.
•
Remove all setting tools, spanners and
installation materials not required before
switching on the drill or drive unit.
Setting tools, spanners and installation materials
located in/on a rotating part of the unit can result
in injuries.
•
Do not overload the drill stand and do not
use it as a ladder or scaffolding.
Overloading or standing on the drill stand can
cause the centre of gravity of the drill stand to
move upwards and the drill stand overturns.
•
Do not use any accessories that have not
been especially provided and recommended
for this drill stand by the manufacturer.
Just because you can attach accessories to your
drill stand is not a guarantee of safe use.
•
Additional signs or other, non-BAIER-
specific parts must not be screwed or
riveted onto the drill stand.
This could damage the drill stand and cause
malfunctions to occur.
•
Note and follow all safety and work
instructions for the accessories used.
•
Never place the feed crank handle on the
hexagon of the tapered shaft to tighten it.
Excessive torques could damage it.

2.6.7 Service / Maintenance / Repair

•
If the power tool is dropped or becomes wet,
have it checked.
A possibly damaged power tool is dangerous
and no longer safe to operate. Before using
the power tool again, have it checked by our
customer service or an authorised service
centre of Maschinenfabrik OTTO BAIER GmbH.
•
Repair and maintenance work may only be
carried out by an authorised workshop of
Maschinenfabrik OTTO BAIER GmbH.
Otherwise, all liability and warranty claims
against Maschinenfabrik OTTO BAIER GmbH
expire.
NOTE
When using new carbon brushes, the machine may
only be operated within the green range for the first
15 minutes - observe LED display in the handle
(Item 1 and 2, see Figure
•
Ensure that original BAIER spare parts and
original BAIER accessories only are used
when needed.
Original parts are available from authorised
dealers. Use of non original parts can cause
damage to the machine and an increased risk of
accidents.
•
Regular servicing by Maschinenfabrik OTTO
BAIER GmbH or a servicing and repair
company authorised by us is specified.
Many accidents are caused by poorly serviced
and maintained power tools.
1 ).
| 37 |