Cleaning The Water Inlet Filters - LG WT7250C Série Manuel Du Propriétaire

Cleaning the Bleach Dispenser
Bleach may build up on the bleach dispenser cover.
Check for buildup and clean the cover once or twice
a month.
Type 1
Remove the cover from the bleach dispenser. Clean
the cover and the opening with warm water.
Type 2
The cover cannot be separated from the dispenser.
Clean the cover using a brush and warm water.
Cleaning the Water Inlet
Filters
If the washer does not fill properly, an error message
will show on the display. The inlet valve filter screens
could be plugged by hard water scale, sediment in
the water supply, or other debris.
CAUTION
• The inlet screens protect the delicate parts of
the inlet valve from being damaged by particles
that could enter the valves with the water supply.
Operating the washer with these filters removed
could cause a valve to stick open resulting in
flooding and/or property damage.
• Do not use the washer without the inlet filters. If
you use the washer without the inlet filters it will
cause leaks and malfunction.
• If you use the washer in an area with hard water,
the inlet filter may clog due to lime buildup.
Turn off both water faucets completely.
1
2
Unscrew the hot and cold water hoses from
the back of the washer.
Carefully remove the filters from the water
3
valves.
4
Remove foreign objects and soak the filters in
white vinegar or a lime scale remover.
If using a lime scale remover, follow the
manufacturer's instructions. Be careful not to
damage the filters while cleaning them.
Rinse filters thoroughly and press them back
5
into place.
6
Flush then reattach the water hoses.
Before reattaching the hoses, flush the hoses and
water lines by running several gallons of water
into a bucket or drain, preferably with the faucets
wide open for maximum flow.
NOTE
• An
message may blink on the display when
the water pressure is low or an inlet filter is clogged
with dirt. Clean the inlet filter.
23
MAINTENANCE