Installation Procedure To Durahoist Mast Or Davit Arm - Honeywell Miller MightEvac Manuel D'utilisation

5.4 Installation Procedure to DuraHoist Mast
(Ref. Fig. 3a, 3b and 3c)
Installation to DuraHoist Mast
Step 1: Install DuraHoist mounting bracket DH-19-MILLER to mast per DuraHoist Instructions.
Step 2: On the MightEvac bracket, insert only the top pin.
Step 3: Holding the MightEvac unit by the handle on the back and making sure the inserted pin is on
the top half of the bracket, hang the MightEvac onto the DuraHoist bracket.
Step 4: Secure by inserting the second pin through the bottom hole sets of both the DuraHoist and the
MightEvac brackets.
To remove the device, simply reverse the installation procedure.
Fig. 3a
Installation to DuraHoist Davit Arm
Step 1: Install DuraHoist mounting bracket DH-AP-11 to
davit arm per DuraHoist Instructions.
Step 2: Follow steps 2 through 4 above to secure Might-
Evac bracket to DuraHoist bracket.
To remove the device, simply reverse the installation
procedure.
Us er In stru ctio ns - Engli sh
or Davit Arm
Fig. 3b
(Ref. Fig. 4)
Fig. 4
10
Fig. 3c