Waldmann RL70LE Mode D'emploi page 21

Connecting
X Remove 8 mm of insulation from both
wires.
X Pass the cable through the cable
gland B, see Fig. 3.
Fig. 4: Pin assignment.
X Unscrew both screws E of the plug D,
see Fig. 4.
X Connect the cable to the plug.
X Tighten both screws.
X Clean the seal A.
Fig. 5: Mounting profile and plug.
X Pull the mounting profile F somewhat
out of the luminaire, see Fig. 5.
X Insert plug D into plug G.
D
E
F
G
H
Fig. 6: Position of mounting profile and lugs.
NOTE: Make sure that the lugs I of the
side part rest on the rail H of the mount-
ing profile, see Fig. 6.
X Place the side part on the luminaire.
X Tighten the three screws of the side
part evenly until seal A makes contact
with inside pipe all around on a width
of at least 2 mm.
X Tighten the cable screw connection.
ENG
I
21