Connecting The Control Line Cable - Pioneer AVIC-F550BT Manuel D'installation

Section
02 Connecting the system

Connecting the control line cable

Green/white (BRAKE)
Used to detect the ON/OFF status of the
handbrake. This lead must be connected to the
power supply side of the handbrake switch.
If this connection is made incorrectly or
omitted, certain functions of this product
will be unusable.
Note
The position of the handbrake switch vary
depending on the vehicle model. For details,
consult your authorised Pioneer dealer or an
installation professional.
WARNING
GREEN/WHITE LEAD AT POWER CONNECTOR IS
DESIGNED TO DETECT PARKED STATUS AND MUST
BE CONNECTED TO THE POWER SUPPLY SIDE OF THE
HANDBRAKE SWITCH. IMPROPER CONNECTION OR
USE OF THIS LEAD MAY VIOLATE APPLICABLE LAW
AND MAY RESULT IN SERIOUS INJURY OR DAMAGE.
10
Engb
Connection method
Clamp the lead of the power supply
side of the handbrake switch.
Clamp firmly with needle-nosed
pliers.
Control line cable
The navigation unit
Pink (REVERSE)
This is connected so that the this product can detect
whether the vehicle is moving forwards or
backwards. Connect the pink lead to the lead whose
voltage changes when the reverse gear is engaged.
Unless connected, the sensor may not detect your
vehicle travelling forward/backward properly, and
thus the position of your vehicle detected by the
sensor may be misaligned from the actual position.
Note
When you use a rear view camera, please make
sure to connect this lead. Otherwise you cannot
switch to the rear view camera picture.
Power supply side
Earth side
Handbrake switch