Publicité
Les langues disponibles
Les langues disponibles
Control panel
Symbol
Button function
ON/OFF button: Turn on and Turn off the whole heater.
Upper tube button: Select and turn On/Off the upper heating tube, and
also adjust its power, there are 5 powers settings, loops from 1 to 5.
Light button: Select and turn On /Off the LED light, and also adjust its
power, there are 5 powers settings, loops from 1 to 5.
Digital displayer: Display the power setting of the working component.
It always displays the power setting of the upper tube if the upper tube
is turned on.
Remote control
Buttons have the same function as those in the control panel.
1.
Plug in the powder cable, a "Beep" sound is heard. The heater is in "Stand By"
status, the ON/OFF is a green light.
2.
Press the "
" button on remote control or control panel, the light will turn
red, and the heater switch to a working status. The heating tube and the LED
light are preset in power 3. (The Heater with memory function and working at
last setting).
3.
Press the "
" or "
" button, the relative tube or light and the digital
displayer will flash for 5 seconds, press the same button to adjust the heating
or light power while the power section is showed in the displayer. The flashing
will stop after 5 seconds and the adjustment is finish.
4.
If you want to turn off only one tube or light, press the relative button and
press "
" button immediately. To turn the tube or the light on again, push
the relative button.
5.
Turn off all tubes and light by pressing "
"Stand By" status.
Warning: Always unplug the heater when it is not in use.
Note: When all tubes and light are on, the digital displayer displays only the power
setting of the upper heating tube. If the upper heating tube is off, it displays that of
the LED light.
Heating arm can work in vertical or horizontal position.
Open the heating arm (Only for Model EH900) as following instructions, and close it
in the reverse direction.
80 | 81
GB
" button , the heater turns to
Publicité
