Ir Repeater Function; When The Tv Remote Control Does Not Work; When The Unit Is Installed In Front Of The Tv; Connecting The Supplied Ir Cable - Pioneer SBX-300 Mode D'emploi

16 Other Functions
En

IR Repeater Function

When the TV remote control
does not work (when the unit
is installed in front of the TV)

When the unit is installed in front of the TV,

the unit may block the remote control sensor
on the TV so that operation by the TV remote
control no longer works. When this happens,
try testing if the TV remote control works using
the two methods below.
Method 1: Move the position of the unit
forward or backward or to the right
or left, or adjust its height.
Method 2: Connect the supplied IR cable.
Connecting the supplied IR
cable
If the TV remote control does not work even
after changing the position of the unit, use the
supplied IR cable.

1 Connecting the supplied IR cable.

2 Affix the IR cable to the rear panel of
the unit.
• Position the transmitter so that it is
aligned with the TV remote control
sensor.
• Use the TV remote control within the
reception range of the remote control
sensor of the unit.
• Peel off the backing on one side of the
supplied double-sided tape and attach
the tape to the IR cable, and then peel off
the backing on the other side and attach
the IR cable to the unit.
Rear of unit
Caution
• Check that the TV cannot be operated with the
remote control of the TV before connecting IR
cable. If it is connected when operation is possible,
the signal output directly from the remote control
of the TV and the signal output via the unit will
interfere with each other.
Note
• For details about the location of the TV remote
control sensor, see the operating instructions for
your TV.
• Select an installation location that best matches
your usage environment.
• Carefully wipe off any dust or objects at the affixing
location.
• This may not work for certain types of TVs. In this
case, try changing the installation position of the
unit.
• The IR repeater function is enabled even when the
power of the unit is off (standby mode).
(1)
IR OUT
TV BD/DVD STB ANALOG
Double-sided
tape
Remote control sensor
(2)