Connecting To Your Tv - Pioneer SBX-300 Mode D'emploi

10 Installing and Connecting the Unit
En
1 Obtain commercially available screws
that fit the holes of the wall mounting
fittings on the rear of the unit.
(25 mm)
4 mm
2 Screw the screws into the wall.
• Screw in the screws until they are
sticking out of the wall by 3 mm to 4 mm.
Wall mounting
screws
(commercially
available)
3 mm to 4 mm
At least 20 mm
3 Hang the unit on the screws by the
holes of the wall mounting fittings on
the rear of the unit.
• Align the holes of the wall mounting
fittings on the rear of the unit and the
screws and then hang the unit on both
screws at the same time.
Caution
• When the unit is mounted to a wall, there is a risk
of it dropping, falling, etc. due to the weight or
mounting method. Take sufficient care not to cause
an accident.
• Select a location for installation/mounting with
sufficient strength to withstand the weight. If you
are unsure of the strength or anything else, consult
with a professional.
• Pioneer is not responsible for any accidents or
damage that result from improper installation/
mounting, incorrect use, modification, disaster,
etc.
Hole of wall mounting fitting
5 mm
10 mm
537 mm
• Do not hang from the unit. Pay special attention to
children. The unit may fall and break, resulting in
injury.
• Do not connect or disconnect the cables while the
unit is mounted to a wall. Install the cables in such
a way that a foot or other object cannot get caught
in them.

Connecting to Your TV

Connect the unit and TV with the supplied
optical digital audio cable.
To enable hearing of the TV audio with the
unit, connect the supplied optical digital audio
cable.
For a TV that only has an analog audio output
terminal, connect the audio output of the TV
and the analog terminal of the unit with a
commercially available audio cable.
Optical digital
audio cable
(included)
Remove the protection cap at
the end and then connect the
cable while paying attention to
the orientation of the connector.
Rear View
TV BD/DVD
If you will not use
the cable for your TV
connection, you can
use it to connect your
CD player or other
audio device.
TV
Analog cable
(commercially
available)
IR OUT
STB ANALOG
If your TV does not
have a digital terminal,
connect it to the analog
terminal.