Electrical Connection - WITA Delta UP 70 Série Traduction Des Instructions De Montage Et De Mise En Service D'origine

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

If the installation position should be changed,
the motor housing must be turned as follows (Fig. 2a to 2d):
• Loosen hexagon socket bolts
• Twist off motor housing
Display HE Pumpen
• Screw in hexagon socket bolts again and tighten..
Fig. 2a

9 Electrical connection

Warning: Risk of death!
Improper installation and improper electrical connection can present a fatal hazard.
Hazards posed by electrical power must be eliminated.
• Only have installation and electrical connection work performed by specialist
staff and in accordance with the applicable regulations (e.g. IEC, VDE etc.).
• Incorrect installation and electrical connection can pose a fatal risk. Prevent
hazards arising from electrical energy.
• Only have installation and electrical connection performed by a specialist and in
line with the valid regulations (e.g. IEC, VDE, etc.)!
• The current type and voltage must correspond with the information on the type plate.
• Observe the specifications of local energy supplier!
• Observe accident prevention regulations!
• Never pull on the power cable
• Do not bend the cable
• Do not place any objects on the cable
• When using the pump in systems at temperatures over 90 °C,
use a connection line that is suitably heat resistant.
• Hazards such as sharp edges and burrs arise during installation.
• When transporting the pump, never hold it by the power cable.
• The pump could cause an injury if it falls.
WITA Delta UP 70-XX
Fig. 2b
Fig. 2c
Operating instrutions
Fig. 2d
27

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wita delta up 70 série

Table des Matières