Tecma X-light Manuel D'installation Et Maintenance page 49

Operation/installation/service manual
Manuale di utilizzo / installazione / manutenzione
X-light / Privilege / Evolution / Breeze / E-Breeze / Silence Plus / Elegance / Saninautico / Prestige
 there is sufficient space to fit all the pipes without damaging or bending them
inappropriately.
 the floor plate can withstand the weight of the toilet and of a potential user, even
during sailing, when these loads may be greater due to the pitching and rolling of the
boat.
 there is sufficient room for a vent valve to be installed above the toilet.
 In the event the toilet is installed below the floating line, make sure there is room for
a vent valve to be installed above it.
 The SHORT versions
the motor, which extends 100 mm below the
bowl.
 The SANINAUTICO model has a minimum
of 3 cm available to allow the cover to be opened,
and there is enough room to house the macerator
sleeves
 The EVOLUTION model has the necessary
requirements to install the vertical fixing plate
(not provided) or to suitably secure the load. This
model is equipped with a specific lower casing
connection system. Once you have installed the
upper part, connect the casing rear hooks to
their seats and turn the nylon plug to lock the
unit.
www.thetfordmarine.com
Manual rev 25.2014
have enough room for
TECMA SRL – Via Flaminia / Loc Castel delle Formiche/ 05030 Otricoli (TR) / Italy
/
MACERATOR TOILETS
TOILET MACERATRICI
©TECMA SRL
49