Tecma X-light Manuel D'installation Et Maintenance page 44

Operation/installation/service manual
Manuale di utilizzo / installazione / manutenzione
X-light / Privilege / Evolution / Breeze / E-Breeze / Silence Plus / Elegance / Saninautico / Prestige
Change flushing mode – from mooring mode to sailing mode (Fig.2)
If you have already adjusted the amount of water and now want to go back to sailing mode:
1) Press and hold the BEFORE USE and AFTER USE buttons for approximately 3 seconds. The
lock LED will flash, indicating that the programming mode is enabled.
2) Release both buttons when the desired water level has been reached
3) The system is now set to sailing mode
Fig.1
Press and hold for about 3 sec
SAILING
MODE
Fig.2
MOORING
MODE
Press and hold for about 3 sec
NOTE: at the end of the cycle, the toilet remains empty if the system is set in "sailing mode".
Alternatively, a small amount of water remains in the toilet if the system is set in "mooring mode".
www.thetfordmarine.com
Manual rev 25.2014
Lockout LED starts blinking
Keep pressing and holding for
Release as soon as the lockout
TECMA SRL – Via Flaminia / Loc Castel delle Formiche/ 05030 Otricoli (TR) / Italy
/
about 4 sec
LED starts blinking
MACERATOR TOILETS
TOILET MACERATRICI
Water starts coming in
Keep pressing and holding the
buttons and release them when
the desired amount of
the bowl
©TECMA SRL
water is in
MOORING
MODE
SAILING
MODE
44