Syncing Two Bases - beautyrest SmartMotion Base 1.0 Manuel Du Propriétaire

syncing two bases

If simultaneous operation of two bases is desired, use the SmartSync™ Cord
STEP 1
Unplug base from power source.
STEP 2
Disconnect the power-down box cable from splitter
cable. Make note where the cable was plugged in
STEP 3
Connect the male end of the sync cord to each splitter
cable. Insert it into the same port you disconnected the
power-down box from in Step 2.
Control Box
Power-Down Box
to connect the electronics of both bases together.
Sync Cord
STEP 4
Connect each power-down box male connection to the
sync cord female connection (Refer to the illustration
below).
STEP 5
Plug base back into the power source.
STEP 6
Check to ensure all cords are securely attached. Both
remotes will now operate both bases simultaneously (If
the remotes become unpaired, see page).
Control Box
Power-Down Box
13