Table des Matières
Publicité
setting up two bases
If a split setup is being installed, plastic connecting straps are provided (one per base) to secure the bases
STEP 1
With the bases in their desired location, slightly loosen both legs
to allow the strap to fit on the leg bolt, between the leg washer
and frame.
STEP 2
Slide side (a) of the connecting strap onto leg bolt. Swing the strap and connect side (b) to the leg bolt. Secure
the strap by shifting to the left.
STEP 3
Re-tighten legs. Do not over tighten. Use the remaining strap and repeat on other end of the base.
12
Connecting straps are secured to the base frame upon delivery.
together. Use both straps to secure the head and foot portions together.
a
b
Publicité
Table des Matières
