Battery Charger And Digital Instrument Configuration - Kränzle SSM 430 Manuel D'utilisation Et Entretien

EN
- Check the incidence of the rubber (60)
blades.
Fig. A = too low
Fig. B = too high
Fig. C = correct position
- Use the grey knob (64) for adjustment,
turning it anticlockwise to increase the
incidence and in the other direction to de-
crease it.
12.1.l - Battery charger and digital
instrument
(Fig. 24)
WARNING:
The machine leaves production with a
standard configuration for operation with
"Sonnenschein" gel batteries.
WARNING:
Disconnect the battery plug from the
socket.
- Remove the cover (61 Fig. 22) by un-
screwing the screws (62 Fig. 22).
Standard configuration with Sonnen-
schein gel batteries
- Remove the cap (66) located under the
batter charger (16).
- Position the switches (DP1 and DP2) as
shown in figure "A".
It is possible to modify the configuration as
follows:
Configuration for gel batteries which are
not Sonnenschein version
- Remove the cap (66) located under the
battery charger (16).
- Position the switches (DP1 and DP2) as
shown in figure "B".
Configuration for acid batteries
- Remove the cap (66) located under the
battery charger (16).
- Position the switches (DP1 and DP2) as
shown in figure "C".
configuration
EN-18