Safety Password; Parameter Setting; Battery Type Setting; Display - Kränzle SSM 430 Manuel D'utilisation Et Entretien

- Select the desired speed by pressing the
buttons (47a) or (47b) (only for the model
equipped with traction).
NOTE:
It is possible to change the speed even during
the working cycle, with the machine in motion
by acting the appropriate buttons.
- Gently touch the touch (20) button and
the machine will start the selected pro-
gram and the working cycle.
NOTE:
It is possible to change the working cycle de-
pending on the work requirements.
In order to change the cycle you must stop
the machine, select a new cycle and activate
the cycle by pressing the touch button (20).
7.0 SAFETY
PASSWORD
The machine can be equipped with a safe-
ty passwords; for enabling it or disabling it,
please contact technical support. If the pass-
word was enabled, in order to enter the num-
bers follow the instructions on the display.
7.1 PARAMETER
SETTING (Fig. 9)
The operator can access the menu to set the
following parameters:
Language;
Battery type;
Brightness / contrast.
Proceed as follows to access the menu:
- Press and hold down (47b) and (52) "
", then press the power button (45) "
" to start the machine until you see the
following display:
-- ID CHECK --
insert password:
-
-
-
-
0
EN-9
Release the pressed keys.
Enter the passwords by pressing the
keys (47a) (47b) until the display shows
the number "10".
Press the button (51) "
password and enter the parameter set-
ting menu; the following screen appears:
general
sets
Language
selection:
min: 0
To browse the parameter setting menu,
press the button (52) "
lowing screens will appear in succession:
general
sets
battery
selection:
min: 0
general
sets

display

30
tune:
min: 5
general
sets
display
bightness:
min: 0
EN
" to confirm the
italiano
max: 3
" and the fol-
gel 24
max: 3
max: 50
5
max: 10