Using The Machine; End Of Use And Switching Off - Kränzle SSM 430 Manuel D'utilisation Et Entretien

EN
Brushing only cycle:
- To perform only the brushing cycle, press
the button (52 Fig. 9) to enable brush ro-
tation.
Press the control located on the handle to
start brush rotation (traction will also start
in models with integrated traction).
Washing, brushing cycle:
- Press the button (52 Fig. 9) to enable
brush rotation, press the button (51 Fig.
9) to enable water dispensing.
Press the control located on the handle to
start brush rotation and/or water dispens-
ing (traction will also start in models with
integrated traction).
Washing, brushing, drying cycle:
- Press the button (50 Fig. 9) to start the
aspirator, button (52 Fig. 9) to enable
brush rotation and press the button (51
Fig. 9) to enable water dispensing.
Press the control located on the handle to
start brush rotation and/or water dispens-
ing (traction will also start in models with
integrated traction).
10.1.c - Using the machine (Fig. 1)
- After starting the machine and selecting
the type of the cycle, start the cleaning
operations by pushing the machine us-
ing the handle (1 Fig. 1) or operating the
sensor (20 Fig. 1) for starting the traction
(for models equipped with this).
NOTE:
Pay attention to particularly delicate floors;
do not use the machine while it's stopped
and the brush rotation on.
For particularly dirty spots, adjust the traction
speed to "0" so the brush will rotate in the
same position, without straining the traction
motor.
NOTE:
The proper cleaning and drying of the floor
is done by pushing the machine forwards;
if you go backwards the machine will not
perform drying; in this phase, always lift the
wiper to avoid damaging the blades.
- Adjust the traction speed (if present) as
shown above.
- If necessary, adjust the quantity of wash-
ing water using the tap (4 Fig. 1).
- Check the battery charge status on the
display.
10.1.d - End of use and switching off
(Fig. 9-13)
- At the end of the cleaning operation, be-
fore turning off the machine, stop water
dispensing and brush rotation using the
buttons (51 Fig. 9) and (52 Fig. 9).
- Lift up the brush by pressing the pedal
(19 Fig. 13) as far as it will go, fitting it in
the designated slot.
- Continue with the aspirator inserted to
aspirate all the liquid on the floor, then
turn off the aspirator by pressing the but-
ton (50 Fig. 9).
- Lift the squeegee (11 Fig. 13) by lifting
the lever (3 Fig. 13).
WARNING:
Always lift the wiper and the end piece
after finishing the cleaning operations be-
cause this avoids the deformation of the
rubber blades and of the brush hairs.
- Press the button (45 Fig. 9) to turn off the
machine.
WARNING:
If the machine will not be used for a few
days, it is recommended to disconnect
the plug (35 Fig. 7-8) from the relative
socket.
EN-12