AudioSonic CDCL-61 Mode D'emploi page 9

4. Press CD: Skip Down/Minute button to adjust MINUTE.
5. Press CD: Stop/Clock adjusting button again to store your setting in memory.
PLAYING A CD
1. Pull to open the CD door and load your disc then close the CD door. (CD printed side facing up)
2. Press Power/Alarm Off button to turn on the unit.
3. Slide Buzzer/Music switch to Music
4. Press Play/Pause button to playing a CD, the LED display will indicate the current playing track number.
Adjust the level of sound by tuning the Volume knob. Press Stop/Clock adjusting button to stop the playing.
NOTE: You can press the CD DISPLAY button to view the number of CD track, then it will return to the clock time
after few seconds.
PAUSE & SKIP FEATURES
1. Start playing your CD as the above mentioned procedures.
2. Press Play/Pause button to pause the playing of the current track. Press the same button again to continue
the playing.
3. Press Up/Hour button to advance one track. Hold this button down to advance quickly through the tracks.
4. Press Down/Minute
beginning track.
PROGRAMMED CD PLAY
This function allows you to preset the order in which a series of tracks will be played.
1. Insert a CD as mentioned above. Press Program/Store button, the Track Memory (e.g. P 01) will appear and
the Program Indicator will flash.
2. Press Up/Hour button or Down/Minute button briefly to locate the particular track, then press the
Program/Store button again to store the selected track(s) in the memory. Up to 20 tracks can be registered
by repeating Step 2.
3. If you want to review the tracks which you have programmed, press Program/Store button repeatedly.
4. After completion of the programming, press Play/Pause button, the tracks will be played in stored order.
5. If you want to clear all programmed tracks, press Program/Store button and then press Stop/Clock adjusting
button.
REPEAT/RANDOM CD PLAY
If you wish to listen to a track all tracks over and over again, the repeat function will allow you to do so.
1. Start playing a CD.
2. Press Play Mode button once to repeat the current track. the Repeat Indicator will flash.
3. Press Play Mode button again to repeat all tracks. The Repeat Indicator will be on.
4. Press PLAY MODE button one more time to enter the RANDOM mode, the RANDOM indicator will alight.
5. If you want to cancel the previous repeat/random setting, press Play Mode button again till to Repeat and
Random Indicator off.
RADIO OPERATION
1. Press Power/Alarm Off button to switch on the unit.
2. Slide Buzzer/Music switch to Music position, and
3. Turn Radio Tuning Knob to select your desired radio station.
4. Adjust Volume knob to your desired level.
5. If you want to switch the Radio off, press Power/Alarm Off button again.
NOTE:
For FM reception, there is FM Antenna/Aerial on the rear of the unit. Extend the Antenna/ Aerial and move it
around to obtain to the best reception.
SETTING THE ALARM
This unit allows you to set two different alarm time during the unit is off or the unit is on Radio or CD mode.
1. Press AL1 button for setting the Alarm 1, the AL1 Indicator will be on and the alarm time will flash.
2. Press Skip Up/Hour button to set the hour and press Skip Down/Minute button to set minute.
3. Press AL1 button again to store your setting in the memory, the AL1 indicator will be still on.
4. Press AL2 button for setting the Alarm 2, the AL2 Indicator will be on and the alarm time will flash. Other
steps are same as above mentioned step 2-3.
position, and Function switch to CD position.
button to return to previous track. Hold this button down to return quickly to the
Function Switch to FM position.
GB3