Installation Precautions - Pioneer Elite SP-EC73 Guide D'utilisation

English
4
BASS MANAGEMENT SETTINGS
If you are using an A/V receiver or surround sound processor
with your speakers, you will need to set the bass management
appropriately. The SP-EC73 center speaker always be set
to SMALL in the receiver's menu. This setting will ensure
that no deep bass signals get into the speaker, which is too
small to play deep bass tones loudly. These deep tones will
not be lost, though—they will be reproduced either by your
front left and right speakers or by your subwoofer. If your
receiver or processor lets you set the crossover frequency
for the SP-EC73, we recommend 80 Hz.

INSTALLATION PRECAUTIONS

• Do not install this speaker system near a stove or other
heating appliance, or put it in a place exposed to the sun.
Such locations may cause the cabinet to change color
and the speaker system to break down.
• Remember that the SP-EC73 is quite heavy, so it is
dangerous to install it in high places such as on walls
or pillars or in other unstable locations unless suitably
secured in place.
Pioneer will not be responsible for any accidents or
damage that may result from improper installation.
CABINET MAINTENANCE
• Use a polishing cloth or dry cloth to wipe off dust and dirt.
• When the cabinet is very dirty, clean with a soft cloth
dipped in some neutral cleanser diluted with six parts
water to one part cleanser, and then wipe again with a
dry cloth. Do not use furniture wax or cleaners.
• Never use paint thinner, benzine, insecticide sprays and
other chemicals on or near the cabinets, since these will
corrode the surfaces
www.pioneerelectronics.com