Cutting Depth; Belt Replacement; Bearing Replacement; Saw Stand - QEP 60024 Manuel D'utilisation

CUTTING DEPTH

1. The recommended cutting depth for all materials is
surface of the cutting table. (See Diagram)
2. To adjust cutting depth, loosen the large motor mounting plate
adjustment knob, and move up or down.

BELT REPLACEMENT

CAUTION: ALWAYS TURN OFF SAW AND UNPLUG FROM POWER SOURCE
BEFORE REMOVING BELT GUARD OR ADJUSTING/CHANGING BELT.
1. Loosen and remove the belt guard screws and take off the belt guard.
2. Loosen the 4 nuts (front & back) on the mounting plate.
3. Gently loosen the motor adjustment clip on the very rear of the motor
mounting plate.
4. Carefully nudge the motor slightly forward so there is a little slack
in the belt.
5. Remove the old belt and replace with the new belt.
6. To reassemble, reverse Steps 1-5.

BEARING REPLACEMENT

1. Follow BLADE INSTALLATION instructions on page 6.
2. Hold down the blade shaft lock until it locks in place. Turn the inner flange
off (counter-clockwise).
3. Follow BELT REPLACEMENT instructions on above. Then, unscrew the
hex screw and take out the pulley.
4. Hold the bearing housing and unscrew the 3 hex screws on the mounting
plate.
5. Now the bearing housing is ready to be removed.
6. To replace all parts, reverse steps in instructions.

SAW STAND

The saw stand includes
The stand folds for compact storage and transportation.
To assemble the stand:
1. Attach the wheels to frame W with the four 1/4" x 1
nuts provided.
2. Place frame W inside the second frame X, and secure the two frames with
the 5/16" x 2" bolts as shown.
3. Put the wheel brakes in the DOWN position, and make sure the wheels are
firmly locked.
4. Set the stand on a firm, flat and level surface. Do not set the stand on soft
soil, on uneven ground, or on debris in the work area. If ground is soft, use
a piece of plywood under the stand to provide a solid, level and even base
for the saw stand.
5. Secure the frame of the saw to the optional stand with the vertical post of
the frame toward the rear of the stand, above the wheels. Insert the 1/4" x
3/4" round head bolt into the square hole of the saw frame and into the
stand. Thread the plastic knob securely onto the bolt, as shown in the drawing.
6. Make sure all bolts and nuts are securely tightened.
(2) wheels with foot
-
1 ⁄ " below the top
4
BEARING HOUSING REPLACEMENT
activated brakes.
3 ⁄ " bolts, washers and
4
8 -
CUTTING DEPTH
BELT REPLACEMENT
SAW STAND
1/4" x 3/4" round head bolt
5/16" x 2" bolts
rest
frame X
(no wheels)
1/4" x 1 ⁄ " bolts
3
4
frame W