Water Pump Installation; Water Pump Safety Guidelines; Cutting Table; Optional Cutting Table Extension - QEP 60024 Manuel D'utilisation

WATER PUMP INSTALLATION

1. Remove the water pump from its box and ensure that it is not cracked or
damaged in any way (See Diagram)
2. Attach the end of the plastic tubing, hanging down from the blade guard,
to the water pump nipple.
3. Place the water pump in the rear of the water tray on its side, with the
water pump nipple also on its side.
4. Next, fill the water tray with water so that its level is higher than the water
intake nozzle.
5. Keep the power cord out of the water and plug it into the 3-prong
receptacle on the back of the cutting head assembly. The pump is
activated by the ON/OFF switch on the electric motor.
NOTE: WATER PUMP
INSTRUCTIONS ARE IN THE FOLLOWING SECTION. PLEASE READ CAREFULLY AND COMPLETELY.

WATER PUMP SAFETY GUIDELINES

1. The pump is equipped with grounding-type attachment plug. Be sure to connect the plug to a properly
grounded grounding type receptacle, to reduce the risk of electric shock.
2. When assembling & installing the water pump system, be sure to fully support the pump and piping to reduce
the chance of pump failure or damage.
3. Never handle the pump by the cord, with wet hands, or when standing on a wet surface.
4. Do not use the pump to pump anything other than water, or other compatible liquids. Never use to pump
gasoline, kerosene, or other combustible or corrosive liquids.
5. Should pump fail, always disconnect from power source before handling pump or attempting to unclog or
service the pump in any way.
6. Never let the pump operate dry. It is self-cooled by pumping liquid. Dry use will cause pump damage and may
cause the motor to fail.
CUTTING TABLE & OPTIONAL CUTTING TABLE EXTENSION
CUTTING TABLE MARKED IN INCHES AND CENTIMETERS FOR ACCURATE CUT DIMENSIONS.
STEPS FOR POSITIONING 45°/90° RIP GUIDE:
1. Set the rip guide by positioning it on the desired dimension and tighten the threaded knob on the rip guide.
Make sure rip guide is firmly tightened to avoid slippage.
2. The rip guide can be used for 90° rip cuts and 45° rip cuts from both the
left and right side. (Note the straight and 45° angled slits on the bottom
of the rip guide in the diagram.)
3. After the rip guide is positioned for the desired cut, place material flush
against the rip guide and the measurement rail. For 45° rip cuts, place the
corner of material in the open slot of the measurement rail.
4. Simply line up the material to be cut with the appropriate pre-marked
lines on the cutting table's rubber mat.
5. Now you are ready to make your cut.
6. For miter cuts, use the miter block attachment included with the saw.
Simply place the lip of the miter block on the measurement rail with the
threaded knobs facing you. Next, tighten both threaded knobs to secure
miter block in place. Place material onto miter block and you are ready to
cut.
7. For greater stability when cutting larger tiles, use the optional cutting-
table extension. This extension snaps easily onto the leading edge of the

cutting table.

SAFETY GUIDELINES & MAINTENANCE
- 7 -
WATER PUMP
INSTALLATION
CUTTING TABLE
45°/90° RIP GUIDE
& MITER BLOCK