Raider Pro Solo RDP-SCDI20S Mode D'emploi Original page 14

14 www.raider.bg
Detail, and attach with appropriate appliances or braces is anchored more firmly and securely than
if you hold it by hand.
1.5.6. Regularly clean your vent cordless drill.
1.5.7. Do not change direction of spindle rotation when the tool is operating. Otherwise drill may
be damaged.
1.5.8. To clean the drill use soft, dry cloth. Never use detergents or alcohol.
2. Construction and use.
Drill is a battery-powered tool. cordless drill consists of brushless electric motor and planetary gear.
Cordless, battery-powered power tools are especially useful for works in interior furnishing, adaptation
of premises etc.
Use the power tool according to the manufacturer's instructions only.
3. Noise level and vibration parameters.
Sound pressure: Lp
Sound power: Lw
Vibration acceleration value for drilling: ahD = 4.56 m / s2
Vibration acceleration value at impact drilling: ah ID = 9.24 m / s2
4. Preparation for operation.
Information about the battery and the charger.
The cordless hammer drill is supplied without a battery and charger. Use only battery and charger from the R20 System
series
5. Operation and settings. Switching on. Switching off.
5.1. Switching on - press the switch button (1).
5.2. Switching off - release the switch button (1).
5.3. Rotational speed control.
Screwing or drilling speed can be controlled during operation by increasing or decreasing pressure
on the switch button (1). Speed control enables soft start, which prevents drill slip when drilling in
gypsum or glaze and helps to control the operation when screwing and unscrewing.
5.4. Overload clutch. Torque control.
Setting the ring (3) in given position causes permanent setting of the clutch to specified torque.
When the set torque is reached, overload clutch releases automatically. It prevents screwing screws t
deep or damaging the drill.
Different screws and materials require different torque to be applied.
The bigger number corresponding to given position, the bigger the torque.
Set the ring (3) to specified torque.
Always start operation with low torque.
Increase the torque gradually until appropriate value is set.
Use higher settings to unscrew screws.
When drilling chooses settings marked with the drill symbol. When this setting is set, the torque is
the greatest.
Knowledge how to choose appropriate settings comes with practice.
Setting the ring in the drilling position deactivates the overload clutch.
5.5. Change of gear.
Drill features gear switch (5), which broadens the range of rotational speed.
Gear I: small speed range, big torque;
Gear II: big speed range, low torque.
Set the switch in appropriate position depending on the works performed. Turn the spindle slightly
if the switch cannot be moved.
Never change the switch (5) position under operation of the drill. It may damage the power tool.
5.6. Working tool installation.
Set the direction selector switch (2) in middle position.
Turning the front ring (4) counter-clockwise, you can set required jaw spread and insert appropriate
drill or driver bit.
Drill or driver bit must be pushed to the chuck limit.
Turn the ring (7) clockwise, tighten hardly.
Deinstallation of the tool is similar to installation, only the sequence of actions is reversed.
Check position of the tool when installing drill or driver bit in the chuck. Use additional magnetic
= 86 dB(A) K=3 dB(A)
A
= 97 dB(A) K=3 dB(A)
A